Fully Programmable First and Second Stage

27 fully independent axis

FIRST STAGE CAPABILITIES

• 3”, 3 ½” 4”, 4 1/2”, Thru Rout or any variation

• Door widths 14” to 4’

• Door length up to 10’

• Programmable revel

• Programmable hinge location

• Programmable corner radius

• Three Degree or Square to the face hinge routing

• Eight Hinge Routers

  • (4) 1 ¼” diameter

  • (4) ½” diameter

• Pre-Drill Single Point (4) drill motors

  • Any hole pattern

  • Most flexible

• Pre-Drill Gang Drill (4) drill motors

• 3 ½” hinge or 4” hinge
  Fastest

• Hinge Application

  • (4) 3 ½” hinge applicators

  • Dual Bowl Feed with rapid color change

    • One bowl feeds (2) applicators

  • Can be specified with 4 front machining heads or 2 front machining heads

SECOND STAGE

• Lock bore circular interpolated from top cut

  • No break out

  • No back up block

  • Clean/Sharp cut
  • ½ pocket cut/pool door/finger pull on hinge pin side of the door
  • Multiple programmable locations
  • Face work feasible and programmable
• Edge prep
  • Programmable edge prep
  • Latch circular interpolated
  • Multiple depth of cuts programmable
  • Multi-point lock
  • Deep pocket lock
  • 5 inches of door edge travel on doors below 3’ 2” (38 inch) in width.
  • 5 inches of door edge travel on doors 3’4” (40 inch) and over.
• Door Handler
  • Automatically advances pallet of doors
  • When pallet is empty ejects empty pallet
  • Holds two pallets at a time 40 doors tall
  • Completely Electro/Mechanical, no pneumatics
  • Bar Code Capable to feed Door spec to DMC